ANSINSPIResidential Inground Swimming Pools-This standard is a revision of ANSI/NSPI-5 , Standard for Residential Inground Swimming. Standards such as ANSI/AHAM RAC, Room Air For homes with inground pools, ANSI/NSPI , Residential Inground Swimming. For the design, equipment, and installation of residential inground swimming pools. This standard is referenced in the International Codes. PURCHASE .
|Published (Last):||20 September 2005|
|PDF File Size:||4.2 Mb|
|ePub File Size:||1.66 Mb|
|Price:||Free* [*Free Regsitration Required]|
Where there are decorative cutouts within vertical members, spacing within the cutouts shall nspj exceed 1. The filter backwashing facilities shall be sufficient to backwash at a rate of twelve 12 gallons per minute per square foot of filter area. This standard does not address return side velocities.
ANSI/APSP Standards & Specifications, ANSI Standards List | APSP
Where a wall of a dwelling serves as part of the barrier, one of the following conditions shall be met: Materials and construction used in swimming pools shall comply with the applicable requirements of this code. Association of pool and spa professionals [APSP]. The maximum slope permitted between point D 2 and the transition point shall not exceed one unit vertical to three units horizontal 1: Section AG – Barrier Requirements: Where provided, vacuum or pressure cleaner fitting s shall be located in an accessible position s at least six inches 6″ and not greater than twelve inches 12″ below the minimum operational water level or as an attachment to the skimmer s.
Disinfection equipment installed for the use of chlorine compounds shall have sufficient capacity to maintain a minimum free chlorine residual of five-tenths 0. These suction outlets shall be piped so that water is drawn through them simultaneously through a vacuum relief-protected line to the pump or pumps.
ANSI/APSP Standards & Specifications List
It shall be unlawful to construct, anssi, install or enlarge any swimming pool in the village except in compliance with all the provisions of this chapter. If the makeup water supply line discharges to a surge or balancing tank, the point of discharge shall be at least six inches 6″ above ndpi rim of the tank. Underwater lighting fixtures shall be approved for the service. Any disinfection method using materials other than chlorine compounds shall be subject to the approval of the building officer.
ANSI/NSPI-5 2003 Standard for Residential Inground Swimming Pools (PDF Download)
For the purposes of this code, pools are classified as private swimming pools or public swimming pools as defined in section of this chapter. Pool filtration pump motors shall meet the following requirements: A minimum of one recirculation system inlet shall be provided for every six hundred fifteen square feet of surface area of the pool.
Please first log in with a verified email before subscribing to alerts.
The barrier shall be designed, to the extent reasonably possible, in such a way so as to discourage easy climbing from the outside. The objective of this standard is to provide recommended minimum guidelines for suction entrapment avoidance in the design, equipment, operation and installation of new and existing swimming pools, wading pools, spas, hot tubs and catch basins for builders, installers, pool operators and service professionals Maximum water velocity limits are: The answers to the above stated questions were given with the understanding that the said questions are to be considered individually and not collectively.
STATE OF FLORIDA
Water drained from the pool shall not be discharged during periods of rain or storms. No swimming pool shall extend two feet six inches 2’6″ or more aboveground.
Swimming pool water recirculation system inlet shall be located so as to produce, so far as possible, uniform circulation of water throughout the pool without the existence of dead spots and to carry pool bottom deposits to the outlets, and shall discharge at a minimum depth of ten inches 10″ below the pool overflow level.
The alarm shall sound continuously for a minimum of 30 seconds immediately after the door is opened and be capable of being heard throughout the house during normal household activities.
All pool and spa nasi or multiple outlet circulation systems shall be equipped with atmospheric vacuum relief should grate covers located therein become missing or broken. Solar pool heating systems shall be permitted to run at higher speeds during periods of usable solar heat gain.
The 203 requirements for residential pools and inground spas shall be as specified in Sections A pool cover which is placed over the water area, and is opened and closed with a motorized mechanism activated by a control switch.
Already Subscribed to this document. Pressure filters shall be equipped with readily accessible air relief valves, loss of head or pressure gauges on the inlet and outlet pipes, and an access head or hole large enough to permit inspection, maintenance and repair work.
The swimming pools’ circulation systems shall consist of pumping equipment, hair and lint catcher, filters, together with the necessary pipe connections to the pool inlets and outlets, facilities and pipe connections necessary for backwashing filter, and filters, and facilities and equipment for disinfecting the pool water.
The effective date is October 1, Swimming pools shall be designed to withstand the water pressure from within and to resist the pressure of the earth when the pool is empty and a certificate of an architect licensed by the state or of a structural engineer licensed by the state, shall be required as evidence of such design characteristics.